Products and Services
DPG-B Series Conveyor
Source:
Cyclonaire Corporation
The DPG-B Series is a gravity loaded, bottom discharge dense phase conveyor best suited for granular, pellitized or powdered materials which are friable or abrasive
The DPG-B Series is a gravity loaded, bottom discharge dense phase conveyor best suited for granular, pellitized or powdered materials which are friable or abrasive. Capacity is rated to 100+ TPH.Bulk unloading / In-plant transfer / Scaling / Batching.
Top gravity load / bottom discharge.
Optimum material-to-air ratios and lowest convey line velocities for maximum rate with gentle handling. Powdered, granular or pellitized materials. 100+ TPH. Dense phase conveyor uses high pressure air to convey material at extremely low line velocities (<400 fpm) and higher material-to-air-ratios (135-40) for less abrasive line wear and less friable / fragile product degradation than with dilute phase conveying, yet optimizing rate.
Top gravity load via single or dual stacked inlet valves / Bottom discharge for highest rates.
Less operator supervision via automated controls.
Specify: Carbon steel, stainless steel or epoxy coated; Dual stacked inlet valves; Load cells. 110 VAC, 50-60 Hz.
20-80 psig convey air ; 80-100 psig control air @ 5-10 scfm.
This unit provides the highest material-to-air ratios and the lowest line velocities resulting in smaller line sized, lower air consumption, reduced dust collection and lower energy cos. Abrasive wear and particle degradation are also minimized with the DPG-B.
These factors translate to lower capital investment and lower operating cost.
Programmable logic controls (PLCs) offer reduced supervision for automated operation.
APPLICATIONS
MATERIALS / CHARACTERISTICS
CAPACITY
BENEFITS & FEATURES
REQUIREMENTS
Cyclonaire Corporation, PO Box 366. York, NE 68467. TEL: 800-445-0730; FAX: 402-362-2001.
